User guide
Table Of Contents
- Introduction
- Installation and Initialization
- Managing the Access Point
- Basic Configuration for an Enterprise
- Access Point Features
- Using Web Interface to Manage the Access Point
- Using SNMP Interface to Manage the Access Point
- Using CLI to Manage the Access Point
- Global Configuration Mode
- General Notes
- Configuring the AP using CLI Commands
- Command Line Interface Mode Overview
- User Exec Mode
- Privileged Exec Mode
- Show Command Tree Structure Command
- Show VLAN Command
- Show MAC ACL Command
- Show RADIUS Server Table Command
- Show RADIUS Supported Profile Table Command
- Show Security Wireless Config Table Command
- Show QoS Profile and Policy Command
- Show QoS EDCA Command
- Show Wireless Properties Command
- Show 11n Wireless Properties Command
- Wireless VAP Command
- Ethernet Interface Command
- Network Configuration Command
- Advaned Filter and Global Filter Command
- TCP-UDP and Static MAC Address Table Commands
- Protocl Filter, Filter Type and Filter Control Table Command
- Access Control and HTTP, Telnet and TFTP Commands
- SNMP Read, Read-Write Password and Trap Host Table Command
- Country Code and Management Commands
- System Information Command
- System Inventory Management Command
- Event Logand ICMP Commands
- IP ARP Statistics and SNTP Command
- Syslog configuration and RADIUS Client Authentication Table Commands
- RADIUS Client Access Command
- Interface Statistics Command
- Wireless Station Statistics Command
- IP Address, Subnet Mask and Gateway Command
- Scalar Objects Commands
- Table Entries Commands
- Table Entry Deletion Command
- Table Entry Edition Command
- VAP Table Commands
- Troubleshooting
- ASCII Character Chart
- Bootloader CLI
- Specifications
- Technical Services and Support
- Statement of Warranty
Using Web Interface to Manage the Access Point AP-800 User Guide
Configuring the Device
59
• Enable the status of the Close Systems to broadcast the beacons.
• Enter the Fragmentation Threshold. The Fragmentation Threshold value range is between 256 to 2346. By
default the Fragmentation Threshold is 2346, when the Fragmentation Threshold is disabled.
NOTE: If you configure the Fragmentation Threshold value between the said range, then only the fragmentation
of the packets takes place.
• Enter the Security Profile Name.
• Enter Radius Profile Name.
• Enter the VAP VLAN ID.
NOTE: The valid range for VLAN ID is between 1 to 4094. If you select a value as -1, then this will disable the
VLAN Tagging.
• Enter the VAP VLAN Priority. (You can enter the priority value between 0-7).
• Enter the QoS Profile Name. Ensure that you select the name that you used for creating the QoS Profile. See
QoS Profile.
NOTE: If the QoS Profile Name is defined as NONE, then the QoS feature will be disabled by default.
• Select the Local MAC Authentication status.
NOTE: If you have enabled this field, then do not enable the Radius MAC Authentication field.
• Select the Radius MAC Authentication status.
• Select the Radius Accounting status.
• Enable the Entry Status for the radio. If you disable the radio, then you cannot configure the Wireless VAP for the
disabled radio.
5. Click OK.
Properties
Using this page, you can configure the properties of wireless interface.
1. Navigate to Configuration > Wireless > Interface 1 > Properties. The Wireless Interface - 1 Properties page will
display.
2. Configure the following parameters: