User guide
Table Of Contents
- Introduction
- Installation and Initialization
- Managing the Access Point
- Basic Configuration for an Enterprise
- Access Point Features
- Using Web Interface to Manage the Access Point
- Using SNMP Interface to Manage the Access Point
- Using CLI to Manage the Access Point
- Global Configuration Mode
- General Notes
- Configuring the AP using CLI Commands
- Command Line Interface Mode Overview
- User Exec Mode
- Privileged Exec Mode
- Show Command Tree Structure Command
- Show VLAN Command
- Show MAC ACL Command
- Show RADIUS Server Table Command
- Show RADIUS Supported Profile Table Command
- Show Security Wireless Config Table Command
- Show QoS Profile and Policy Command
- Show QoS EDCA Command
- Show Wireless Properties Command
- Show 11n Wireless Properties Command
- Wireless VAP Command
- Ethernet Interface Command
- Network Configuration Command
- Advaned Filter and Global Filter Command
- TCP-UDP and Static MAC Address Table Commands
- Protocl Filter, Filter Type and Filter Control Table Command
- Access Control and HTTP, Telnet and TFTP Commands
- SNMP Read, Read-Write Password and Trap Host Table Command
- Country Code and Management Commands
- System Information Command
- System Inventory Management Command
- Event Logand ICMP Commands
- IP ARP Statistics and SNTP Command
- Syslog configuration and RADIUS Client Authentication Table Commands
- RADIUS Client Access Command
- Interface Statistics Command
- Wireless Station Statistics Command
- IP Address, Subnet Mask and Gateway Command
- Scalar Objects Commands
- Table Entries Commands
- Table Entry Deletion Command
- Table Entry Edition Command
- VAP Table Commands
- Troubleshooting
- ASCII Character Chart
- Bootloader CLI
- Specifications
- Technical Services and Support
- Statement of Warranty
Access Point Features AP-800 User Guide
Monitoring the Device
55
• Stats Requests: This parameter represents the number of RADIUS Access Requests messages transmitted from
the client to the server since client startup.
• Retransmissions: This parameter represents the number of RADIUS Access Requests messages retransmitted
from the client to the server since client startup.
• Stats Responses: This parameter represents the total number of RADIUS Access messages received from the
accounting server since system startup.
• Malformed Responses: This parameter represents the number of malformed RADIUS Access Response
messages received since system satrtup.
• Stats Timeouts: This parameter represents the total number of timeouts for RADIUS Access Request messages
since system startup.
• Unknown Types: This parameter represents the number of messages with unknown Radius Message Code
since system startup.
• Packets Dropped: This parameter represents the number of Radius message which do not contain any EAP
payloads or EAP State machine do not have any valid EAP state data since system startup.
For more information on how to configure the above mentioned features, refer to the following chapters:
• Using Web Interface: Using Web Interface to Manage the Access Point
• Using SNMP Interface: Using SNMP Interface to Manage the Access Point
• CLI Interface: Using CLI to Manage the Access Point