Installation guide
Table Of Contents
- Preface
- Introduction
- Management and Monitoring Capabilities
- Device Initialization
- Basic Configuration
- Device Configuration
- Device Management
- Device Monitoring
- Troubleshooting
- Frequency Domains and Channels
- Bootloader CLI and Scan Tool
- ASCII Character Chart
- Frequently Asked Questions (FAQs)
- Glossary
- Abbreviations
- Statement of Warranty
- Technical Services and Support
Device Management
ORiNOCO® 802.11n Access Points - Software Management Guide 97
4. Click Update, to update the device with new configuration.
5. Click Update & Reboot, to update and automatically reboot the device.
6. To update the device with Text Based Configuration files, select Text Based Config and configuration screen appears:
Figure 6-8 Update Configuration by using TFTP - Text Based Config
Configure the following parameters.
7. Click Update, to update the device with new configuration file.
8. Click Load, to apply the updated changes.
9. Click Update & Load, to update and load the configuration file onto the device.
:
• Reboot the device when you update the device with Binary Configuration file.
• Update & Load the device when you update the device with Text Based Configuration file.
• It is recommended not to navigate away from the update screen while the update is in progress.
6.2.3 Retrieve from Device
6.2.3.1 Retrieve from Device by using HTTP
To retrieve Configuration files, Event Logs and Text Based Templates from the device by using HTTP, follow the following steps:
1. Navigate to MANAGEMENT > File Management > Retrieve from Device > HTTP. The configuration screen
appears.
Parameter Description
Server IP Address Specifies the IP Address of the TFTP server.
To configure, enter the Server IP Address.
File Name Specifies the name of the Text based file (including the file extension) that has to be
downloaded onto the device.
To configure, enter the Text based File Name with extension.