Installation guide
Table Of Contents
- Preface
- Introduction
- Management and Monitoring Capabilities
- Device Initialization
- Basic Configuration
- Device Configuration
- Device Management
- Device Monitoring
- Troubleshooting
- Frequency Domains and Channels
- Bootloader CLI and Scan Tool
- ASCII Character Chart
- Frequently Asked Questions (FAQs)
- Glossary
- Abbreviations
- Statement of Warranty
- Technical Services and Support
Device Management
ORiNOCO® 802.11n Access Points - Software Management Guide 91
In the System Information screen, you can view and configure the following configurable parameters:
Click OK, to save the configured parameters.
6.1.2 Inventory Management
The Inventory Management feature provides inventory information about the device. Navigate to MANAGEMENT >
System > Inventory Management. The System Inventory Management Table appears.
Parameter Description
System Up-Time Specifies a read-only parameter that represents the operational time of the device since its
last reboot.
System Description Specifies a read-only parameter that provides description about the system, including the
device name, current version of the firmware and the current build number.
System Name Specifies the name that is assigned to the device.
To configure, enter a System Name of maximum 64 characters.
Email Specifies the email address of the person administering the device.
To configure, enter an email address of minimum 6 and maximum 32 characters in the
Email box.
Phone Number Specifies the phone number of the person administering the device.
To configure, enter a phone number of minimum 6 and maximum 32 characters in the
Phone Number box.
Location Specifies the location where the device is installed.
To configure, enter a location name of minimum 0 and maximum 255 characters in the
Location box.
GPS Longitude Specifies the longitude at which the device is installed.
To configure, enter a longitude value of minimum 0 and maximum 255 characters (in the
format required by your Network Management System) in the GPS Longitude box.
GPS Latitude Specifies the latitude at which the device is installed.
To configure, enter a latitude value of minimum 0 and maximum 255 characters (in the
format required by your Network Management System) in the GPS Latitude box.
GPS Altitude Specifies the altitude at which the device is installed.
To configure, enter an altitude value of minimum 0 and maximum 255 characters (in the
format required by your Network Management System) in the GPS Altitude box.