Installation guide
Table Of Contents
- Preface
- Introduction
- Management and Monitoring Capabilities
- Device Initialization
- Basic Configuration
- Device Configuration
- Device Management
- Device Monitoring
- Troubleshooting
- Frequency Domains and Channels
- Bootloader CLI and Scan Tool
- ASCII Character Chart
- Frequently Asked Questions (FAQs)
- Glossary
- Abbreviations
- Statement of Warranty
- Technical Services and Support
Device Configuration
ORiNOCO® 802.11n Access Points - Software Management Guide 80
Click Add, to save the configured entry.
:
• The maximum number of Static MAC Filters that can be added are 200.
• Wired and Wireless MAC Address cannot have broadcast and multicast MAC address.
5.8.3 Advanced Filters
The Advanced Filters feature enable you to block the specific IP Protocol traffic on the network.
To configure Advanced Filters, navigate to CONFIGURATION > Filters > Advanced Filters. The Advanced Filters screen
appears.
Figure 5-41 Advanced Filters
Configure the following parameters:
Status Specifies the status of the newly created filter. Filters are applied between the wired and
wireless devices, only when the status is enabled.
By default, it is enabled. To disable, click Disable from the Status box.