Installation guide
Table Of Contents
- Preface
- Introduction
- Management and Monitoring Capabilities
- Device Initialization
- Basic Configuration
- Device Configuration
- Device Management
- Device Monitoring
- Troubleshooting
- Frequency Domains and Channels
- Bootloader CLI and Scan Tool
- ASCII Character Chart
- Frequently Asked Questions (FAQs)
- Glossary
- Abbreviations
- Statement of Warranty
- Technical Services and Support
Device Configuration
ORiNOCO® 802.11n Access Points - Software Management Guide 75
Figure 5-37 Protocol Filters
Tabulated below are the ‘Protocol Filter’ parameters and the method to configure the configurable parameters:
Parameter Description
Filtering Control Specifies the parameter, used to configure the interface on which filtering has to be applied.
By default, it is disabled. It can be configured as:
– Ethernet: Packets are examined at the ethernet interface.
– Wireless: Packets are examined at the wireless interface.
– All interfaces: Packets are examined at both ethernet and wireless interface.
To configure, select an interface from the Filtering Control drop down menu.