Installation guide
Table Of Contents
- Preface
- Introduction
- Management and Monitoring Capabilities
- Device Initialization
- Basic Configuration
- Device Configuration
- Device Management
- Device Monitoring
- Troubleshooting
- Frequency Domains and Channels
- Bootloader CLI and Scan Tool
- ASCII Character Chart
- Frequently Asked Questions (FAQs)
- Glossary
- Abbreviations
- Statement of Warranty
- Technical Services and Support
Device Configuration
ORiNOCO® 802.11n Access Points - Software Management Guide 60
5.5.3 MAC Access Control
The MAC Access Control feature of AP device allows only the authorized wireless clients to access the network. MAC
Authentication is supported only on the wireless interface. Navigate to CONFIGURATION > Security > MAC ACL. The MAC
Access Control screen appears.
Figure 5-22 MAC Access Control
Configure the following parameters:
Click OK and COMMIT, to save the configuration.
: To enable MAC Access Control, you should enable Local MAC Authentication in VAP.
5.5.3.1 Add Wireless Clients to MAC Access Control Table
To add a MAC address of a wireless client in the MAC Access Control Table, click Add in the MAC Access Control screen.
The MAC ACL Add Row screen appears.
Figure 5-23 MAC ACL Add Row
Parameter Description
Operation Type Specifies the two types of operations, Allow or Deny.
– Allow: Allows only the wireless clients in the MAC Access Control Table to access the
wireless network.
– Deny: Does not allow the wireless clients in the MAC Access Control Table to access
the wireless network.
By default, the Operation Type taken is Deny. To configure, select Allow from the drop
down menu.