Installation guide
Table Of Contents
- Preface
- Introduction
- Management and Monitoring Capabilities
- Device Initialization
- Basic Configuration
- Device Configuration
- Device Management
- Device Monitoring
- Troubleshooting
- Frequency Domains and Channels
- Bootloader CLI and Scan Tool
- ASCII Character Chart
- Frequently Asked Questions (FAQs)
- Glossary
- Abbreviations
- Statement of Warranty
- Technical Services and Support
ORiNOCO® 802.11n Access Points - Software Management Guide 27
5
Device Configuration
Note that you can also configure the device by using CLI and SNMP interfaces. Hence, we recommend you to also refer the
ORiNOCO® 802.11n Access Points - Reference Guide.
This chapter explains the step-by-step procedure to configure the following features on the device, by using Web
Interface:
• System
• Network
— IP Configuration
— Link Integrity
— Spanning Tree Protocol (STP)
• Ethernet
• Wireless Interface
— Interface 1
— Properties
— 11n Properties
— Virtual Access Point (VAP)
— Interface 2
• Security
— Wireless Security
— RADIUS
— MAC Access Control
• Quality of Service (QoS)
— Enhanced Distributed Channel Access (EDCA)
— 802.1d to IP DSCP
— 802.1d to 802.1p
— QoS Profile
— QoS Policy
• Virtual Local Area Network (VLAN)
— VLAN Ethernet Configuration
• Filters
— Protocol Filters
— Static MAC Address Filters
— Advanced Filters
— TCP/UDP Port Filters
— Storm Threshold Filters
— Packet Forwarding
• DHCP
— DHCP Server