Installation guide
Table Of Contents
- Preface
- Introduction
- Management and Monitoring Capabilities
- Device Initialization
- Basic Configuration
- Device Configuration
- Device Management
- Device Monitoring
- Troubleshooting
- Frequency Domains and Channels
- Bootloader CLI and Scan Tool
- ASCII Character Chart
- Frequently Asked Questions (FAQs)
- Glossary
- Abbreviations
- Statement of Warranty
- Technical Services and Support
Device Initialization
ORiNOCO® 802.11n Access Points - Software Management Guide 21
Before applying commit, the system displays a confirmation message, as shown in the following figure:
Figure 3-6 Commit
Click OK, if you wish to commit the changed parameters.
On successful Commit operation, the following screen appears:
Figure 3-7 Commit Status
If the configured parameters requires reboot, on committing the following screen appears.
Figure 3-8 Commit Status with Reboot Message
3.3.2 Reboot
Reboot operation is required for any change in the key parameters to take effect. For example, settings such as configuring
the Radio Mode, IP Address, and Network Mode need reboot to take effect. See Parameters requiring Reboot, for more
details. On clicking REBOOT, system displays a confirmation window as shown below.