Installation guide
Table Of Contents
- Preface
- Introduction
- Management and Monitoring Capabilities
- Device Initialization
- Basic Configuration
- Device Configuration
- Device Management
- Device Monitoring
- Troubleshooting
- Frequency Domains and Channels
- Bootloader CLI and Scan Tool
- ASCII Character Chart
- Frequently Asked Questions (FAQs)
- Glossary
- Abbreviations
- Statement of Warranty
- Technical Services and Support
Device Management
ORiNOCO® 802.11n Access Points - Software Management Guide 109
Figure 6-19 SYSLOG Host Table Add Row
Configure the following parameters:
Click Add, to add an entry in the SYSLOG Host Table.
6.4 Simple Network Time Protocol (SNTP)
SNTP allows you to synchronize the date and time of the device with the configured time servers. When this feature is
enabled, the device will attempt to retrieve the time of day information from the configured time servers (primary or
secondary) and, if successful, will update the relevant time objects in the device. Use the following commands to configure
and view the Simple Network Time Protocol.
Navigate to MANAGEMENT > SNTP. The SNTP screen appears.
Figure 6-20 SNTP
You can view and configure the following configurable parameters:
Parameter Description
IP Address Enter the IP address of the SYSLOG server in the IP Address box.
Host Port Enter a Host Port in the Host Port box. The value ranges from 0 to 65535.
Comment Enter any comments in the Comment box.