Installation guide
Table Of Contents
- Preface
- Introduction
- Management and Monitoring Capabilities
- Device Initialization
- Basic Configuration
- Device Configuration
- Device Management
- Device Monitoring
- Troubleshooting
- Frequency Domains and Channels
- Bootloader CLI and Scan Tool
- ASCII Character Chart
- Frequently Asked Questions (FAQs)
- Glossary
- Abbreviations
- Statement of Warranty
- Technical Services and Support
Device Management
ORiNOCO® 802.11n Access Points - Software Management Guide 107
Figure 6-17 SNMP Trap Host Table Add Row
Configure the following parameters:
Click Add, to add an entry in the SNMP Trap Host Table.
6.3.4 SYSLOG Host Table
System log messages are generated by the device by sending requests at various instances to the system log server. The
system log messages are lost on device reboot. Navigate to MANAGEMENT > Services > SYSLOG Host Table
Figure 6-18 SYSLOG Host Table
Parameter Description
IP Address Enter the IP address to which SNMP traps will be delivered, in the IP Address box.
Password To access SNMP traps, enter password in the Password box. A minimum of 6 and a
maximum of 32 characters are allowed.
: Applicable only to SNMP version “SNMP V1-V2c”.
Comment Enter any comments in the Comment box.
Entry Status Select the Entry Status as either Enable or Disable from the drop down menu.