Installation guide
Table Of Contents
- Preface
- Introduction
- Management and Monitoring Capabilities
- Device Initialization
- Basic Configuration
- Device Configuration
- Device Management
- Device Monitoring
- Troubleshooting
- Frequency Domains and Channels
- Bootloader CLI and Scan Tool
- ASCII Character Chart
- Frequently Asked Questions (FAQs)
- Glossary
- Abbreviations
- Statement of Warranty
- Technical Services and Support
Device Management
ORiNOCO® 802.11n Access Points - Software Management Guide 105
• If you select the SNMP version as SNMP V3, then following screen appears:
Figure 6-16 SNMP Version - SNMPV3
Configure the following parameters:
Parameter Description
Security Level Specifies the security level of the device. The supported
Security Levels for the device are:
– None: For no authentication
– AuthNoPriv: For Extensible Authentication
– AuthPriv: For both Authentication and Privacy
(Encryption)
By default, it is taken as AuthPriv. To configure, select the
Security Level, from the drop down menu.
Priv Protocol Specifies the type of privacy (or encryption) protocol.
By, default Priv Protocol is AES-128. To configure, select
the encryption standard as either AES-128 (Advanced
Encryption Standard) or DES (Data Encryption Standard)
from the drop down menu.
: Applicable only when the Security Level is set to
AuthPriv.