Installation guide
Table Of Contents
- Preface
- Introduction
- Management and Monitoring Capabilities
- Device Initialization
- Basic Configuration
- Device Configuration
- Device Management
- Device Monitoring
- Troubleshooting
- Frequency Domains and Channels
- Bootloader CLI and Scan Tool
- ASCII Character Chart
- Frequently Asked Questions (FAQs)
- Glossary
- Abbreviations
- Statement of Warranty
- Technical Services and Support
Device Management
ORiNOCO® 802.11n Access Points - Software Management Guide 102
Configure the following parameters in the HTTP/HTTPS screen:
Click OK and then Reboot the device for the changes to take effect.
6.3.2 Telnet/SSH
Navigate to MANAGEMENT > Services > Telnet/SSH. The configuration screen appears.
Figure 6-14 Telnet/SSH
Parameter Description
Password Specifies the password, essential to access the device by using web interface.
By default, the password is set to public. To configure, enter a new password in the
Password box. The password should be alphanumeric with minimum of 6 and maximum of
32 characters.
: Special characters like - = \ " ' ? / space are not allowed in the password.
HTTP Specifies the HTTP status. HTTP allows the user to access the device through a web
interface.
To configure, Select Enable or Disable from the drop down menu.
HTTP Port Specifies the port number for the HTTP interface.
By default, the port number is 80. To configure, enter a new HTTP Port.
HTTPS Specifies the HTTPS status. HTTPS allows the user to access the device through a web
interface.
To configure, select Enable or Disable from the drop down menu. The password
configuration for HTTPS is same as configured for HTTP.