User guide

Using Web Interface to Manage the Access Point AP-8000 User Guide
Managing the Device
82
• GPS Altitude: Enter the value in the format required by your network management system.
• Country Code: The country in which the AP will be used.
NOTE: You must reboot the AP in order for country selection to take effect.
NOTE: Country selection is available only on APs with model numbers ending in -WD. If country selection is available,
however, it must be set before any interface parameters can be configured.
CAUTION: Romania does not support in the 20 and 40 MHz band in 11na mode. For UK 11na does not support 40 MHz
band. The table below specifies the details:
Click OK.
Figure 6-36 System Information Page
System Inventory Management Component
This page provides information about the device hardware, firmware, and software version information. For more
information, See Using CLI to Manage the Access Point.
Country allow 11g allow11a turbo allow11gturbo allow11ng20 allow11ng40 allow11na20 allowna40
Romania Yes No Yes Yes Yes No No
UK Yes No Yes Yes Yes Yes No