User guide

Using Web Interface to Manage the Access Point AP-8000 User Guide

Configuring the Device

• Enable the status of Closed Systems to broadcast the beacons.

• Enter the Fragmentation Threshold. The Fragmentation Threshold value range is between 256 to 2346. By

default the Fragmentation Threshold is 2346, when the Fragmentation Threshold is disabled.

NOTE: If you configure the Fragmentation Threshold value between the said range, then only the fragmentation

of the packets takes place.

• Enter the Security Profile Name.

• Enter Radius Profile Name.

• Enter the VAP VLAN ID.

NOTE: The valid range for VLAN ID is between 1 to 4094. If you select a value as -1, then this will disable the

VLAN Tagging.

• Enter the VAP VLAN Priority. (You can enter the priority value between 0-7).

• Enter the QoS Profile Name. Ensure that you select the name that you used for creating the QoS Profile. See

QoS Profile.

NOTE: If the QoS Profile Name is defined as NONE, then the QoS feature will be disabled by default.

• Select the Local MAC Authentication status.

NOTE: If you have enabled this field, then do not enable the Radius MAC Authentication field.

• Select the Radius MAC Authentication status.

• Select the Radius Accounting status.

• Enable the Entry Status for the radio. If you disable the radio, then you cannot configure the Wireless VAP for the

disabled radio.

5. Click OK.

NOTE: Follow the above mentioned steps if you want to configure VAP for Interface 2.

Properties

Using this page, you can configure the properties of wireless interface.

1. Navigate to Configuration > Wireless > Interface 1 > Properties. The Wireless Interface - 1 Properties page will

display.

2. Configure the following parameters: