User guide

Using CLI to Manage the Access Point AP-8000 User Guide
Managing the Device Using CLI Commands
135
Possible completions:
Email System Contact Email
exit Exit from configure mode
gps-altitude System GPS Altitude
gps-latitude System GPS Latitude
gps-longitude System GPS Longitude
location System Location
phone-number System Contact Phone Number
system-name System Name Configuration
(config-mgmt-sys-sysinfo)# email [e-mail]
(config-mgmt-sys-sysinfo)# system-name name
(config-mgmt-sys-sysinfo)# phone-number 1234567890
(config-mgmt-sys-sysinfo)# location systemlocation
(config-mgmt-sys-sysinfo)# gps-altitude -121.8893;
(config-mgmt-sys-sysinfo)# gps-latitude 37.3321;
(config-mgmt-sys-sysinfo)# gps-longitude -121.8893;
(config-mgmt-sys-sysinfo)#exit
(config-mgmt-sys)# exit
(config-mgmt)# exit
(config)# exit
Device-Name# show management system information
// RUNNING-CONFIGURATION //
// System Information Configuration //
system {
description: System Description
OID: 1.3.6.1.4.1.841
uptime: 0-00:23:54.67
name: System Name
contact-mail: [e-mail]
phone-number: Contact Phone Number
location-name: System Location
gps-longitude: -121.8893
gps-latitude: 37.3321
gps-altitude: 10
productdescr: ORiNOCO AP-8000 @ WD v1.0.0 SN-08IN39111235 v1.0.2(202181)
}
System Management Configuration
You can configure the operational parameters like commit, reboot and factory-reset using the following commands.
(config-mgmt)#system
(config-mgmt-sys)# management
(config-mgmt-sys-sysmgmt)# ?
Possible completions:
commit System Management Config Commit
exit Exit from configure mode
factory-reset Management Factory Reset
reboot System Inventory Management Reboot
restore System Managment Config Restore
(config-mgmt-sys-sysmgmt)# commit 1
(config-mgmt-sys-sysmgmt)# factory-reset 0
(config-mgmt-sys-sysmgmt)# reboot 1