User guide

Using CLI to Manage the Access Point AP-8000 User Guide
Configuring the Device Using CLI Commands
111
--inventory-mgmt ?
--component-table
--security-id
--management
Show Command Tree Structure for Device Monitor
#Show ?
---monitor ?
--event-log
--icmp-statistics
--interface-statistics
--ip-arp-statistics
--sntp
--syslog
--radius ?
--client-access-statistics
--client-auth-statistics
Device Configuration
To configure the device parameters in Global configuration mode, type “?” to list the available commands.
>enable
#configure
(config)#?
dev-configure Device Configuration
dev-management Device Management Configuration
dev-monitor Device Monitor Configuration
To proceed with configuration, select each interface and enter the required parameters and their configurations.
Wireless Configuration
Properties Table Configuration
Perform the following to configure wireless properties table parameters in Interface 1 and Interface 2.
Interface 1
(config)#dev-configure
(config-dev<config>)#interface
(config-dev<config>-if)#wireless
(config-dev<config>-if-wireless)#properties-tbl
(config-dev<config>-if-wireless-properties<tbl>)# radio 1 auto-channel-selection enable
(config-dev<config>-if-wireless-properties<tbl>)#radio 1 auto-rate-selection enable
(config-dev<config>-if-wireless-properties<tbl>)#radio 1 cellsize large
(config-dev<config>-if-wireless-properties<tbl>)#radio 1 current- channel-bandwidth 40
changes in current channel bandwidth reboot requires….
(config-dev<config>-if-wireless-properties<tbl>)# radio 1 current-operating-channel 5
(config-dev<config>-if-wireless-properties<tbl>)# radio 1 dtim 1
(config-dev<config>-if-wireless-properties<tbl>)# radio 1 operational-mode DOT11NG
changes in operational mode reboot requires….
(config-dev<config>-if-wireless-properties<tbl>)# radio 1 radio-status enable
(config-dev<config>-if-wireless-properties<tbl>)#radio 1 tpc 1
(config-dev<config>-if-wireless-properties<tbl>)# radio 1 transmit-rate 0
(config-dev<config>-if-wireless-properties<tbl>)# radio 1 vap-beacon-interval 100
(config-dev<config>-if-wireless-properties<tbl>)# radio 1 vap-rts-threshold 2346
Interface 2
(config)#dev-configure
(config-dev<config>)#interface
(config-dev<config>-if)#wireless