User guide

Using CLI to Manage the Access Point AP-8000 User Guide
Configuring the Device Using CLI Commands
110
show Show
Device-Name#
NOTE: The username and password are case-sensitive. If you enter incorrect Password, then a message is displayed
stating that the password is incorrect.
When you enter “
Show” command at the CLI Command prompt, this will list the following features that you can configure
or view:
Show Command Tree Structure Command
Show Command Tree Structure for Device Configuration
# Show ?
---configure ?
---filtering ?
---advanced-filter-table
---control
---intra-bss
---protocol-filter ?
---filter-control
---filter-type
---table
---static-mac-addr-filter ?
---port-filter-ctrl
---table
--interface
---ethernet
---wireless ?
---properties-table
---properties-11n-table
---vap-table
---network
---security ?
--mac-acl
--wireless-config-table
--radius-server-profile-table
---qos ?
--l2l3qos ?
--dot1d-to-dot1p-mapping-table
--dot1d-to-ipdscp-mapping-table
--policy-table
--profile-table
---vlan
Show Command Tree Structure for Device Management
#Show ?
---management ?
--access-control
--http
--snmp ?
--read-password
--read-write-password
--trap-host-table
--system ?
--country-code
--feature
--information