User's Manual

10
Hardware Installation
Follow these steps to install the OpenAir CompactFlash Card in
a Compaq iPAQ:
1. If not already attached, connect the snap-on antenna to the
CompactFlash Card.
2. Insert the Compaq iPAQ into the CompactFlash Expan-
sion Pack (if not already attached).
3. If necessary, remove the cover from the CompactFlash
slot.
4. Insert the OpenAir CompactFlash Card connector-side
first into the CompactFlash slot.
Note:
The OpenAir Compact Flash Card will only fit into
the CompactFlash slot in one direction so that the
back of card faces out).
The Compaq iPAQ will automatically detect the OpenAir
CompactFlash Card. Follow the Software Configuration
instructions below to complete the installation of the
CompactFlash Card.
Note:
If the iPAQ does not automatically recognize the
OpenAir CompactFlash Card, reset the iPAQ. The
reset button is located on the bottom of the iPAQ.
Refer to the documentation that came with the iPAQ
for more information.