User`s guide

26
RJ-45 Output Plug (per channel) — Access Point Side
Use two standard straight-through Ethernet cables that include all 8 wires (4 pairs) to
connect the Harmony Power System to a network hub/switch and to an AP Power Over
LAN Module or Harmony 802.11a/802.11b Access Point. Figure 6 illustrates this type
of connection for an 802.11b Access Point.
Figure 6: Cable Pin-out Model for Access Point Connection to the Power System
Pin Number Description
1 Rx Data Signal from Access Point
2 Rx Data Signal from Access Point
3 Tx Data Signal to Access Point
4DC power
5DC power
6 Tx Data Signal to Access Point
7DC power
8DC power
9 Connector shielding