User`s guide

Installing the Harmony Power System 17
Step 2: Rack Mount the Harmony Power System
(Optional)
The Harmony Power System is 1U (Unit) high and fits in most standard 19-inch
equipment racks. Follow the procedure below if you intend to rack mount the unit:
WARNING! Disconnect all cables and remove the self-adhesive pads from the under-
side of the Power System before attempting to rack mount the unit.
1. Place the Harmony Power System right side up on a hard, flat surface with the
front of the unit facing towards you.
2. Position the mounting bracket over the mounting holes on one side of the unit, as
shown in Figure 5.
Figure 5: Rack Mount Bracket Assembly
3. Insert the four screws, included in the product package, and tighten with a
screwdriver.
Note: You must use the screws supplied with the mounting brackets. Damage
caused to the unit by using incorrect screws is not covered by the product
warranty.
4. Repeat Steps #2 and 3 for the other side of the unit.
5. Insert the unit into the 19-inch rack and use screws and a screwdriver to secure it
in place (screws to connect the rack mount bracket to a 19-inch equipment rack
are not provided). Ensure that the ventilation holes are not obstructed.
6. Proceed to Step 3: Power Up the Harmony Power System.