User`s guide

Introduction 10
Access Point Overview
Figure 1: Harmony 802.11a Access Point Model 8569/8570
To p Pa ne l L E D s
The top panel LEDs are (from left to right) the Status Wireless and
Ethernet LEDs.
Status LED
The Status LED gives information about the Access Point.
Status LED
LED Behavior Indication
Off Unit not powered on
Lit solid amber Unit is initializing or is not partnered with an
AP Controller
Blinking amber Unit needs new firmware
Lit solid green Unit is operational and partnered with an
AP Controller
Blinking green Unit is operating in Independent mode
(without an AP Controller)
Blinking red Problem with unit