System information

222 The Tools Menu
Filtering by Address
This rule lets you look at traffic by address or address pair. Setup options are described
below:
Filtering for Errors
Choose which types of errors you want to filter for. When you select multiple error
conditions to filter for, the conditions are chained with logical ORs. In other worlds, if you
check “CRC” and “Packet too small,” you will filter for packets that contain either of
those errors in addition packets that include both.
You can set address by MAC,
IP, or IPv6
You can filter for a single address,
or a range of addresses.
Enter or select the desired
address or a range of
addresses. You can also select
Click
OK to save changes and exit, or Cancel to exit without saving.
You can filter for packets sent
or received by Address 1 and
Address 2.
Any Address.
If selected, allows you to filter
by port in addition to Address.