System information

116 The Statistics Menu
both). By examining historical information you can tell whether this is a chronic
problem, which might indicate the need for a faster connection, or an acute problem,
which might indicate a failure of some sort. Observer does this passively; therefore,
the Access Point is not affected.
Available Views
• List and Dials View
• 3D Column Chart View
•Pie View
Settings
To use the Access Points Load Monitor you must first configure the mode. This is
done by clicking the Settings button, which will then display the Access Points Load
Monitor Setup dialog.
• Select a Router from the list (of stations). Do so by highlighting the station. This
list is read from your address/alias list.
• “Router speed (Baud)” textbox—this is the device’s defined throughput (in other
words, enter 54000000 for 802.11a/g access points, or 11000000 for 802.11b
access points.