Installation guide

Wireless Guide 53
6
Installing the Cisco Aironet
Adapter / Driver
Overview
This chapter describes how to install the Cisco Aironet 340/350 adapter card
and driver for the Sniffer software.
 Installing the Cisco Aironet in Windows NT 4.0 on page 53
 Installing the Cisco Aironet in Windows XP on page 58
 Installing the Cisco Aironet in Windows 2000 on page 60
 Using the Cisco Aironet as a Normal Network Adapter on page 64
 Cisco Aironet Installation Notes and Issues on page 66
Installing the Cisco Aironet in Windows NT 4.0
This section describes how to install the Cisco Aironet 340 adapter and driver
on a Windows NT 4.0 system.
NOTE: The Cisco Aironet 350 adapter is not supported on Windows NT, and
therefore no driver is provided.
To install the Cisco Aironet 340 adapter and driver in Windows NT 4.0:
1 After installing the Sniffer software, remove any installed copies of the
Aironet Client Utility.
2 Remove any installed adapter drivers (either a previous version of the
Sniffer driver or another vendor’s driver) for the Cisco Aironet adapter.
You remove drivers in Windows NT from the Adapters tab of the
Network control panel.
3 Restart the computer and log in to Windows NT as an Administrator.
4 Install Version 4.15 or later of Cisco’s Aironet Client Utility:
a Download Version 4.15 or later of Cisco’s Aironet Client Utility
from the Cisco web site (
http://www.cisco.com).