User's Manual
Table Of Contents
- Contents
- 1. Introduction
- The Harmony Family
- System Requirements
- The Product Package
- 2. Installation
- Installation Procedure
- Mounting Option
- LED Indicators
- Power Requirements
- 3. Wirefree Operation
- Harmony Architecture
- The IEEE 802.11b Specification
- Roaming Between Harmony 802.11b Access Points
- Roaming Guidelines
- 4. Configuration Parameters
- Basic Settings
- AP Name
- Physical Address
- Enable AP
- Partnered APC
- Channel
- Supported Clients
- SSID
- IP Addressing
- Security Settings
- WEP Encryption
- WEP Key Size
- WEP Keys
- Advanced Settings
- Supported Rates
- RTS/CTS
- 5. Performance Hints
- Microwave Ovens
- Range
- 6. Troubleshooting
- How to Obtain Help with Your LAN Installation
- LED Error Codes
- Common Problems and Solutions
- A. Parameters
- B. IEEE 802.11b Direct Sequence Channels
- C. Harmony 802.11b Access Point Specifications
- D. How to Reach Technical Support
- Index
17
4. Configuration Parameters
The first time a Harmony 802.11b Access Point is connected to the network, the AP
Controller will automatically configure the Access Point using the AP AutoConfigure
Default settings.
In addition, a Harmony 802.11b Access Point may be manually configured via the
Harmony system’s Web browser interface. Refer to the Harmony Access Point
Controller Model 7560 User’s Guide for information on how to access the Web
browser interface.
This chapter describes the configuration parameters for a Harmony 802.11b Access
Point.
You may configure the following parameters for a Harmony 802.11b Access Point
using the Web browser interface:
❑ Basic Settings
❑ Security Settings
❑ Advanced Settings
Each of these options is discussed in detail below.
Basic Settings
The Basic Settings tab allows you to configure the following parameters.
AP Name
You can assign a name to the Harmony 802.11b Access Point. The AP Name cannot
exceed 63 characters. The AP Controller assigns an AP Name to each Access Point that
it automatically detects and configures. By default, the AP Name is the device’s physical
address.