User's Manual

Installation 16
4. The Link LED on the rear panel will light to indicate that the Access Point has a
network connection. The LED is lit green if connected to a 100Base-TX network
and lit amber if connected to a 10Base-T network.
5. By default, the Harmony 802.11a Access Point will attempt to find an AP
Controller to partner with. If you have one or more AP Controllers on the network,
an AP Controller will automatically detect and configure the Access Point over the
network (assuming you have not disabled the Harmony System’s ability to
automatically detect new Access Points). Refer to the
Harmony Access Point
Controller User’s Guide
for more information on how to configure an Access Point.