User guide
Table Of Contents
- Introduction
- Installation and Initialization
- System Status
- Advanced Configuration
- System
- Network
- Interfaces
- Management
- Filtering
- Alarms
- Bridge
- QoS
- Radius Profiles
- SSID/VLAN/Security
- Monitoring
- Commands
- Troubleshooting
- Command Line Interface (CLI)
- General Notes
- Command Line Interface (CLI) Variations
- CLI Command Types
- Using Tables and Strings
- Configuring the AP using CLI commands
- Set Basic Configuration Parameters using CLI Commands
- Set System Name, Location and Contact Information
- Set Static IP Address for the AP
- Change Passwords
- Set Network Names for the Wireless Interface
- Enable 802.11d Support and Set the Country Code
- Enable and Configure TX Power Control for the Wireless Interface
- Configure SSIDs (Network Names), VLANs, and Profiles
- Download an AP Configuration File from your TFTP Server
- Backup your AP Configuration File
- Set up Auto Configuration
- Other Network Settings
- Configure the AP as a DHCP Server
- Configure the DNS Client
- Configure DHCP Relay
- Configure DHCP Relay Servers
- Maintain Client Connections using Link Integrity
- Change Wireless Interface Settings
- Set Ethernet Speed and Transmission Mode
- Set Interface Management Services
- Configure Syslog
- Configure Intra BSS
- Configure Wireless Distribution System
- Configure MAC Access Control
- Set RADIUS Parameters
- Set Rogue Scan Parameters
- Set Hardware Configuration Reset Parameters
- Set VLAN/SSID Parameters
- Set Security Profile Parameters
- CLI Monitoring Parameters
- Parameter Tables
- CLI Batch File
- ASCII Character Chart
- Specifications
- Technical Services and Support
- Statement of Warranty
Advanced Configuration AP-700 User Guide
Alarms
81
Flash Memory Trap Group
TFTP Trap Group
Image Trap Group
oriTrapDHCPFailed Response to the DHCP client request not
received; device not dynamically assigned an IP
address
Major
oriTrapDNSClientLookupFailure DNS client attempts to resolve a specified
hostname (DNS lookup) and a failure occurs
because either the DNS server is unreachable or
there is an error for the hostname lookup. Trap
specifies the hostname that was being resolved.
Major
oriTrapSSLInitializationFailure SSL initialization failure Major
oriTrapWirelessServiceShutdown Wireless interface has shutdown services for
wireless clients
Informational
oriTrapWirelessServiceResumed Wireless interface has resumed service and is
ready for wireless client connections
Informational
oriTrapSSHInitializationStatus SSH initialization status Major
oriTrapVLANIDUserAssignment User is assigned a VLAN ID from the RADIUS
server
Informational
oriTrapDHCPLeaseRenewal AP requests DHCP renewal and receives new
information from the DHCP server. Information
includes the DHCP server IP address that replied
to the DHCP client request, and the IP address,
subnet mask, and gateway IP address returned
from the DHCP server.
Informational
oriTrapTemperatureAlert Temperature is above or below acceptable
operating margin.
Critical
Temperature is within 5°C of upper or lower limit. Major
Trap Name Description Severity Level
oriTrapFlashMemoryEmpty No data present in flash memory Informational
Flash Memory Corrupted Flash memory corrupted Critical
oriTrapFlashMemoryRestoringLastKnownGoo
dConfiguration
Current/original configuration data file is found to
be corrupted, and the device loads the last known
good configuration file
Informational
Trap Name Description Severity Level
oriTrapTFTPFailedOperation TFTP operation failed Major
oriTrapTFTPOperationInitiated TFTP operation Initiated Informational
oriTrapTFTPOperationCompleted TFTP operation completed Informational
Trap Name Description Severity Level
oriTrapZeroSizeImage Zero size image loaded onto device Major
Trap Name Description Severity Level