User guide

Advanced Configuration AP-700 User Guide
Interfaces
53
Traps Generated During Wireless Service Shutdown (and Resume)
The following traps are generated during wireless service shutdown and resume, and are also sent to any configured
Syslog server.
When the wireless service is shut down on a wireless interface, the AP generates a trap called
oriTrapWirelessServiceShutdown.
When the wireless service is resumed on a wireless interface, the AP generate a trap called
oriTrapWirelessServiceResumed.
Channel Blacklist Table
The Channel Blacklist table contains all available channels (channels vary based on regulatory domain). It can be used to
manually blacklist channels, and it also reflects channels that have been automatically blacklisted by the Dynamic
Frequency Selection/Radar Detection (DFS/RD) function. In the ETSI (Europe) and TELEC (Japan) regulatory domains,
channels are blacklisted automatically when radar is detected; when a channel has been automatically blacklisted, the
Radar Detected status is set to True, and the channel will remain blacklisted for 30 minutes. Additionally, an administrator
can blacklist channels manually to prevent their being used when ACS is enabled. To blacklist a channel manually:
1. Click on Configure > Interfaces > Wireless A.
2. Scroll down to the Channel Blacklist heading.
Figure 4-11 Channel Blacklist Table
3. Click Edit in the Channel Blacklist Table
4. Set Blacklist Status to Enable.