User guide
Table Of Contents
- Introduction
- Installation and Initialization
- System Status
- Advanced Configuration
- System
- Network
- Interfaces
- Management
- Filtering
- Alarms
- Bridge
- QoS
- Radius Profiles
- SSID/VLAN/Security
- Monitoring
- Commands
- Troubleshooting
- Command Line Interface (CLI)
- General Notes
- Command Line Interface (CLI) Variations
- CLI Command Types
- Using Tables and Strings
- Configuring the AP using CLI commands
- Set Basic Configuration Parameters using CLI Commands
- Set System Name, Location and Contact Information
- Set Static IP Address for the AP
- Change Passwords
- Set Network Names for the Wireless Interface
- Enable 802.11d Support and Set the Country Code
- Enable and Configure TX Power Control for the Wireless Interface
- Configure SSIDs (Network Names), VLANs, and Profiles
- Download an AP Configuration File from your TFTP Server
- Backup your AP Configuration File
- Set up Auto Configuration
- Other Network Settings
- Configure the AP as a DHCP Server
- Configure the DNS Client
- Configure DHCP Relay
- Configure DHCP Relay Servers
- Maintain Client Connections using Link Integrity
- Change Wireless Interface Settings
- Set Ethernet Speed and Transmission Mode
- Set Interface Management Services
- Configure Syslog
- Configure Intra BSS
- Configure Wireless Distribution System
- Configure MAC Access Control
- Set RADIUS Parameters
- Set Rogue Scan Parameters
- Set Hardware Configuration Reset Parameters
- Set VLAN/SSID Parameters
- Set Security Profile Parameters
- CLI Monitoring Parameters
- Parameter Tables
- CLI Batch File
- ASCII Character Chart
- Specifications
- Technical Services and Support
- Statement of Warranty
Advanced Configuration AP-700 User Guide
Network
44
Figure 4-8 SNTP Configuration Screen
You can configure and view the following parameters within the SNTP screen:
• SNTP Status: Select Enable or Disable from the drop-down menu. The selected status will determine which of the
parameters on the SNTP screen are configurable.
NOTE: When SNTP is enabled, it will take some time for the AP to retrieve the time of day from the configured time
servers and update the relevant date and time parameters.
• Addressing Format: If SNTP is enabled, choose whether you will use the host name or the IP address to configure
the primary/secondary SNTP servers. If these servers are configured with the host name, the DNS client feature must
be enabled and configured properly.
• Primary Server Name or IP Address: If SNTP is enabled, enter the host name or IP address of the primary SNTP
server.
• Secondary Server Name or IP Address: If SNTP is enabled, enter the host name or IP address of the secondary
SNTP server.
• Time Zone: Select the appropriate time zone from the drop down menu.
• Daylight Savings Time: Select the number of hours to adjust for daylight savings time.
• Time and Date Information: When SNTP is disabled, the following time-relevant objects are manually configurable.
When SNTP is enabled, these objects are grayed out: