User guide
Table Of Contents
- Introduction
- Installation and Initialization
- System Status
- Advanced Configuration
- System
- Network
- Interfaces
- Management
- Filtering
- Alarms
- Bridge
- QoS
- Radius Profiles
- SSID/VLAN/Security
- Monitoring
- Commands
- Troubleshooting
- Command Line Interface (CLI)
- General Notes
- Command Line Interface (CLI) Variations
- CLI Command Types
- Using Tables and Strings
- Configuring the AP using CLI commands
- Set Basic Configuration Parameters using CLI Commands
- Set System Name, Location and Contact Information
- Set Static IP Address for the AP
- Change Passwords
- Set Network Names for the Wireless Interface
- Enable 802.11d Support and Set the Country Code
- Enable and Configure TX Power Control for the Wireless Interface
- Configure SSIDs (Network Names), VLANs, and Profiles
- Download an AP Configuration File from your TFTP Server
- Backup your AP Configuration File
- Set up Auto Configuration
- Other Network Settings
- Configure the AP as a DHCP Server
- Configure the DNS Client
- Configure DHCP Relay
- Configure DHCP Relay Servers
- Maintain Client Connections using Link Integrity
- Change Wireless Interface Settings
- Set Ethernet Speed and Transmission Mode
- Set Interface Management Services
- Configure Syslog
- Configure Intra BSS
- Configure Wireless Distribution System
- Configure MAC Access Control
- Set RADIUS Parameters
- Set Rogue Scan Parameters
- Set Hardware Configuration Reset Parameters
- Set VLAN/SSID Parameters
- Set Security Profile Parameters
- CLI Monitoring Parameters
- Parameter Tables
- CLI Batch File
- ASCII Character Chart
- Specifications
- Technical Services and Support
- Statement of Warranty
34
AP-700 User Guide
4
Advanced Configuration
This chapter contains information on configuring settings in the following categories:
• System: Configure specific system information such as system name and contact information.
• Network: Configure IP, DNS client, DHCP server, DHCP Relay Agent, DHCP Relay Servers, Link Integrity, and SNTP
settings.
• Interfaces: Configure the Access Point’s interfaces: Wireless and Ethernet. Configure the Channel Blacklist Table and
a Wireless Distribution System (WDS).
• Management: Configure the Access Point’s management Passwords, IP Access Table, and Services such as
configuring secure or restricted access to the AP via SNMPv3, HTTPS, or CLI. Configure Secure Management, SSL,
Secure Shell (SSH), and RADIUS Based Access Management. Set up Automatic Configuration for Static IP.
• Filtering: Configure Ethernet Protocol filters, Static MAC Address filters, Advanced filters, and Port filters.
• Alarms: Configure the Alarm (SNMP Trap) Groups, the Alarm Host Table, and the Syslog features.
• Bridge: Configure the Spanning Tree Protocol, Storm Threshold protection, Intra BSS traffic, and Packet Forwarding.
• QoS: Configure Wireless Multimedia Enhancements/Quality of Service parameters and QoS policies.
• Radius Profiles: Configure RADIUS features such as RADIUS Access Control and Accounting.
• SSID/VLAN/Security: Configure SSIDs, VLANs, and security profiles. Configure security features such as MAC
Access Control, WPA, 802.11i (WPA2), WEP Encryption, and 802.1x.
To configure the AP using the HTTP/HTTPS interface, you must first log in to a web browser. See Logging In for
instructions.
You may also configure the AP using the command line interface. See Command Line Interface (CLI) for more
information.
To configure the AP via HTTP/HTTPS:
1. Click the Configure button located on the left-hand side of the screen.