User guide
Table Of Contents
- Introduction
- Installation and Initialization
- System Status
- Advanced Configuration
- System
- Network
- Interfaces
- Management
- Filtering
- Alarms
- Bridge
- QoS
- Radius Profiles
- SSID/VLAN/Security
- Monitoring
- Commands
- Troubleshooting
- Command Line Interface (CLI)
- General Notes
- Command Line Interface (CLI) Variations
- CLI Command Types
- Using Tables and Strings
- Configuring the AP using CLI commands
- Set Basic Configuration Parameters using CLI Commands
- Set System Name, Location and Contact Information
- Set Static IP Address for the AP
- Change Passwords
- Set Network Names for the Wireless Interface
- Enable 802.11d Support and Set the Country Code
- Enable and Configure TX Power Control for the Wireless Interface
- Configure SSIDs (Network Names), VLANs, and Profiles
- Download an AP Configuration File from your TFTP Server
- Backup your AP Configuration File
- Set up Auto Configuration
- Other Network Settings
- Configure the AP as a DHCP Server
- Configure the DNS Client
- Configure DHCP Relay
- Configure DHCP Relay Servers
- Maintain Client Connections using Link Integrity
- Change Wireless Interface Settings
- Set Ethernet Speed and Transmission Mode
- Set Interface Management Services
- Configure Syslog
- Configure Intra BSS
- Configure Wireless Distribution System
- Configure MAC Access Control
- Set RADIUS Parameters
- Set Rogue Scan Parameters
- Set Hardware Configuration Reset Parameters
- Set VLAN/SSID Parameters
- Set Security Profile Parameters
- CLI Monitoring Parameters
- Parameter Tables
- CLI Batch File
- ASCII Character Chart
- Specifications
- Technical Services and Support
- Statement of Warranty
Command Line Interface (CLI) AP-700 User Guide
Parameter Tables
212
Security Parameters
MAC Access Control Parameters
MAC Access Control Table
Rogue Scan Configuration Table
The Rogue Scan Configuration Table allows you to enable or disable Rogue Scan and configure the scanning
parameters.
802.1x Parameters
Hardware Configuration Reset
The Hardware Configuration Reset commands allows you to enable or disable the feature and to change the password to
be used for configuration reset during boot up.
Name Type Value Access CLI Parameter
MAC Address Control Group N/A R macacl
Status Integer enable
disable (default)
RW aclstatus
Operation Type Integer passthru (default)
block
RW macacloptype
Name Type Value Access CLI Parameter
MAC Address Control
Table
Table N/A R macacltbl
Table Index N/A N/A R index
MAC Address PhysAddress User Defined RW macaddr
Comment (optional) DisplayString User Defined
max 254 characters
RW cmt
Status (optional) Integer enable (default)
disable
delete
RW status
Name Type Value Access CLI Parameter
Rogue Scan
Configuration Table
Table N/A R rscantbl
Rogue Scan Mode Integer Bkscan (1)
Contscan (2)
RW mode
Rogue Scan Cycle Time Integer 1 - 1440 RW cycletime
Rogue Scan
Configuration Table Index
Integer 3 or 4 RW index
Rogue Scan Status Integer enable
disable
RW status
Name Type Value Access CLI Parameter
802.1x Group Group N/A R dot1xauthcfg
802.1x Supplicant
Timeout
Integer32 3 - 60 seconds
(recommended range)
RW dot1xsupptimeout