User guide
Table Of Contents
- Introduction
- Installation and Initialization
- System Status
- Advanced Configuration
- System
- Network
- Interfaces
- Management
- Filtering
- Alarms
- Bridge
- QoS
- Radius Profiles
- SSID/VLAN/Security
- Monitoring
- Commands
- Troubleshooting
- Command Line Interface (CLI)
- General Notes
- Command Line Interface (CLI) Variations
- CLI Command Types
- Using Tables and Strings
- Configuring the AP using CLI commands
- Set Basic Configuration Parameters using CLI Commands
- Set System Name, Location and Contact Information
- Set Static IP Address for the AP
- Change Passwords
- Set Network Names for the Wireless Interface
- Enable 802.11d Support and Set the Country Code
- Enable and Configure TX Power Control for the Wireless Interface
- Configure SSIDs (Network Names), VLANs, and Profiles
- Download an AP Configuration File from your TFTP Server
- Backup your AP Configuration File
- Set up Auto Configuration
- Other Network Settings
- Configure the AP as a DHCP Server
- Configure the DNS Client
- Configure DHCP Relay
- Configure DHCP Relay Servers
- Maintain Client Connections using Link Integrity
- Change Wireless Interface Settings
- Set Ethernet Speed and Transmission Mode
- Set Interface Management Services
- Configure Syslog
- Configure Intra BSS
- Configure Wireless Distribution System
- Configure MAC Access Control
- Set RADIUS Parameters
- Set Rogue Scan Parameters
- Set Hardware Configuration Reset Parameters
- Set VLAN/SSID Parameters
- Set Security Profile Parameters
- CLI Monitoring Parameters
- Parameter Tables
- CLI Batch File
- ASCII Character Chart
- Specifications
- Technical Services and Support
- Statement of Warranty
Command Line Interface (CLI) AP-700 User Guide
Parameter Tables
202
Management Parameters
Secure Management Parameters
SNMP Parameters
HTTP Parameters
* The help link must be set to an HTTP address. Use the forward slash character ("/") rather than the backslash character ("\") when configuring
the Help Link location.
Name Type Value Access CLI Parameter
Secure Management Integer 1 (enable)
2 (disable)
RW securemgmtstatus
Name Type Value Access CLI Parameter
SNMP Group N/A R snmp
SNMP Management
Interface Bitmask
Interface Bitmask 0 or 2 = No interfaces
(disable)
1 or 3 = Ethernet
4 or 6 = Wireless
5 or 7 = All interfaces
(default is 7)
RW snmpifbitmask
Read Password DisplayString User Defined
public (default)
6 - 32 characters
W snmprpasswd
Read/Write Password DisplayString User Defined
public (default)
6 - 32 characters
W snmprwpasswd
SNMPv3 Authentication
Password
DisplayString User Defined
public (default)
6 - 32 characters
W snmpv3authpasswd
SNMPv3 Privacy
Password
DisplayString User Defined
public (default)
6 - 32 characters
W snmpv3privpasswd
Name Type Value Access CLI Parameter
HTTP Group N/A R http
HTTP Management
Interface Bitmask
Interface Bitmask 0 or 2 = No interfaces
(disable)
1 or 3 = Ethernet
4 or 6 = Wireless
5 or 7 = All interfaces
(default is 7)
RW httpifbitmask
HTTP Password DisplayString User Defined (6 - 32
characters)
W httppasswd
HTTP Port Integer User Defined
Default = 80
RW httpport
Help Link* DisplayString User Defined RW httphelplink
SSL Status Integer enable/disable RW sslstatus
SSL Certificate
Passphrase
DisplayString User Defined W sslpassphrase