User guide
Table Of Contents
- Introduction
- Installation and Initialization
- System Status
- Advanced Configuration
- System
- Network
- Interfaces
- Management
- Filtering
- Alarms
- Bridge
- QoS
- Radius Profiles
- SSID/VLAN/Security
- Monitoring
- Commands
- Troubleshooting
- Command Line Interface (CLI)
- General Notes
- Command Line Interface (CLI) Variations
- CLI Command Types
- Using Tables and Strings
- Configuring the AP using CLI commands
- Set Basic Configuration Parameters using CLI Commands
- Set System Name, Location and Contact Information
- Set Static IP Address for the AP
- Change Passwords
- Set Network Names for the Wireless Interface
- Enable 802.11d Support and Set the Country Code
- Enable and Configure TX Power Control for the Wireless Interface
- Configure SSIDs (Network Names), VLANs, and Profiles
- Download an AP Configuration File from your TFTP Server
- Backup your AP Configuration File
- Set up Auto Configuration
- Other Network Settings
- Configure the AP as a DHCP Server
- Configure the DNS Client
- Configure DHCP Relay
- Configure DHCP Relay Servers
- Maintain Client Connections using Link Integrity
- Change Wireless Interface Settings
- Set Ethernet Speed and Transmission Mode
- Set Interface Management Services
- Configure Syslog
- Configure Intra BSS
- Configure Wireless Distribution System
- Configure MAC Access Control
- Set RADIUS Parameters
- Set Rogue Scan Parameters
- Set Hardware Configuration Reset Parameters
- Set VLAN/SSID Parameters
- Set Security Profile Parameters
- CLI Monitoring Parameters
- Parameter Tables
- CLI Batch File
- ASCII Character Chart
- Specifications
- Technical Services and Support
- Statement of Warranty
Command Line Interface (CLI) AP-700 User Guide
Parameter Tables
195
SNTP Parameters
Link Integrity Parameters
Link Integrity IP Target Table
Name Type Value Access CLI Parameter
SNTP Group Group N/A R sntp
SNTP Status Integer enable
disable
RW sntpstatus
Primary Server Name or
IP Address
DisplayString 0 - 255 characters RW sntpprisvr
Secondary Server Name
or IP Address
DisplayString 0 - 255 characters RW sntpsecsvr
Time Zone Integer See MIB for
requirements
RW sntptimezone
Daylight Savings Time Integer -2
-1
0
+1
+2
RW sntpdaylightsaving
Year Integer32 N/A RW sntpyear
Month Integer32 1 - 12 RW sntpmonth
Day Integer32 1 - 31 RW sntpday
Hour Integer32 0 - 23 RW sntphour
Minutes Integer32 0 - 59 RW sntpmins
Seconds Integer32 0 - 59 RW sntpsecs
Addressing Format Integer ipaddress
name
RW sntpaddrfmt
Name Type Value Access CLI Parameter
Link Integrity Group N/A R linkint
Link Integrity Status* Integer enable
disable (default)
RW linkintstatus
Link Integrity Poll Interval Integer 500 - 15000 ms
(in increments of 500ms)
500 ms (default)
RW linkintpollint
Link Integrity Poll
Retransmissions
Integer 0 - 255
5 (default)
RW linkintpollretx
Name Type Value Access CLI Parameter
Link Integrity IP Target Table Table N/A R linkinttbl
Table Index Integer 1 - 5 N/A index
Target IP Address IpAddress User Defined RW ipaddr
Comment (optional) DisplayString User Defined (up to 254
characters)
RW cmt
Status (optional) Integer enable
disable (default)
delete
RW status