User guide
Table Of Contents
- Introduction
- Installation and Initialization
- System Status
- Advanced Configuration
- System
- Network
- Interfaces
- Management
- Filtering
- Alarms
- Bridge
- QoS
- Radius Profiles
- SSID/VLAN/Security
- Monitoring
- Commands
- Troubleshooting
- Command Line Interface (CLI)
- General Notes
- Command Line Interface (CLI) Variations
- CLI Command Types
- Using Tables and Strings
- Configuring the AP using CLI commands
- Set Basic Configuration Parameters using CLI Commands
- Set System Name, Location and Contact Information
- Set Static IP Address for the AP
- Change Passwords
- Set Network Names for the Wireless Interface
- Enable 802.11d Support and Set the Country Code
- Enable and Configure TX Power Control for the Wireless Interface
- Configure SSIDs (Network Names), VLANs, and Profiles
- Download an AP Configuration File from your TFTP Server
- Backup your AP Configuration File
- Set up Auto Configuration
- Other Network Settings
- Configure the AP as a DHCP Server
- Configure the DNS Client
- Configure DHCP Relay
- Configure DHCP Relay Servers
- Maintain Client Connections using Link Integrity
- Change Wireless Interface Settings
- Set Ethernet Speed and Transmission Mode
- Set Interface Management Services
- Configure Syslog
- Configure Intra BSS
- Configure Wireless Distribution System
- Configure MAC Access Control
- Set RADIUS Parameters
- Set Rogue Scan Parameters
- Set Hardware Configuration Reset Parameters
- Set VLAN/SSID Parameters
- Set Security Profile Parameters
- CLI Monitoring Parameters
- Parameter Tables
- CLI Batch File
- ASCII Character Chart
- Specifications
- Technical Services and Support
- Statement of Warranty
Command Line Interface (CLI) AP-700 User Guide
Other Network Settings
180
Shutdown/Resume Wireless Service
[Device-Name]>set wif 3 wssstatus <1 (resume)/2 (shutdown)>
Set Load Balancing Maximum Number of Clients
[Device-Name]>set wif 3 lbmaxclients <1–63>
Set the Multicast Rate (802.11a/b/g)
[Device-Name]>set wif 3 multrate <6, 12, 24
(Mbits/sec)>
Enable/Disable Super Mode (802.11a/g only)
[Device-Name]>set wif 3 supermode <enable/disable>
Enable/Disable Turbo Mode (802.11a/g only)
[Device-Name]>set wif 3 turbo <enable/disable>
NOTE: Super mode must be enabled on the interface before Turbo mode can be enabled.
Configure Antenna Diversity
[Device-Name]>set wif 3 atdiversity <1, 2, 5(auto)> (see below)
[Device-Name]>reboot 0
NOTE: See Antennas for more information on internal and external antenna ports.
Set the Distance Between APs
[Device-Name]>set wif 3 distaps <1–5> (see below)
[Device-Name]>reboot 0
Value Corresponding Antenna Enabled
1 802.11a/b/g (connector 1)
2 802.11a/b/g (connector 2)
5 (auto) Both antennas
Value Distance Between APs
1 Large
2Medium
3Small
4Mini
5Micro