User guide
Table Of Contents
- Introduction
- Installation and Initialization
- System Status
- Advanced Configuration
- System
- Network
- Interfaces
- Management
- Filtering
- Alarms
- Bridge
- QoS
- Radius Profiles
- SSID/VLAN/Security
- Monitoring
- Commands
- Troubleshooting
- Command Line Interface (CLI)
- General Notes
- Command Line Interface (CLI) Variations
- CLI Command Types
- Using Tables and Strings
- Configuring the AP using CLI commands
- Set Basic Configuration Parameters using CLI Commands
- Set System Name, Location and Contact Information
- Set Static IP Address for the AP
- Change Passwords
- Set Network Names for the Wireless Interface
- Enable 802.11d Support and Set the Country Code
- Enable and Configure TX Power Control for the Wireless Interface
- Configure SSIDs (Network Names), VLANs, and Profiles
- Download an AP Configuration File from your TFTP Server
- Backup your AP Configuration File
- Set up Auto Configuration
- Other Network Settings
- Configure the AP as a DHCP Server
- Configure the DNS Client
- Configure DHCP Relay
- Configure DHCP Relay Servers
- Maintain Client Connections using Link Integrity
- Change Wireless Interface Settings
- Set Ethernet Speed and Transmission Mode
- Set Interface Management Services
- Configure Syslog
- Configure Intra BSS
- Configure Wireless Distribution System
- Configure MAC Access Control
- Set RADIUS Parameters
- Set Rogue Scan Parameters
- Set Hardware Configuration Reset Parameters
- Set VLAN/SSID Parameters
- Set Security Profile Parameters
- CLI Monitoring Parameters
- Parameter Tables
- CLI Batch File
- ASCII Character Chart
- Specifications
- Technical Services and Support
- Statement of Warranty
Installation and Initialization AP-700 User Guide
Hardware Installation
18
Hardware Installation
Perform the following procedures to install the AP hardware:
• Attach Cables
• Install the Security Cover (Optional)
• Mount the AP-700
• Power On the Unit
Attach Cables
Cabling without Power Over Ethernet (PoE)
1. Plug the barrel of the power cable from the power supply into the power jack (the leftmost port in the back of the unit,
see figure).
2. Connect one end of an Ethernet cable (not supplied) to the unit’s LAN port (see figure). The other end of the cable
should not be connected to another device until after installation is complete:
• Use a straight-through Ethernet cable if you intend to connect the unit to a switch, hub, or patch panel.
NOTE:
AP-700 units using external antennas must be installed by a suitably trained professional installation
technician or by a qualified installation service.
NOTE:
Before installing and using this product, see the Safety and Regulatory Compliance Guide.
NOTE:
Avant d’installer et d’utiliser ce produit, consultez le manuel Safety and Regulatory Compliance
Guide.
NOTA:
Prima dell’installazione e dell’utilizzo del prodotto, consultare il documento Safety and Regulatory
Compliance Guide (Guida per la sicurezza e la conformità alle normative).
ANMERKUNG:
Lesen Sie vor der Installation und Verwendung dieses Produkts die wichtigen Informationen im
Handbuch Safety and Regulatory Compliance Guide.
NOTA:
Antes de instalar y utilizar este producto, consulte el manual Safety and Regulatory Compliance
Guide (Manual de seguridad y cumplimiento de la normativa).
注記 :
この製品をインストールして使用する前に、
『
Safety and Regulatory Compliance Guide
』
.