User guide
Table Of Contents
- Introduction
- Installation and Initialization
- System Status
- Advanced Configuration
- System
- Network
- Interfaces
- Management
- Filtering
- Alarms
- Bridge
- QoS
- Radius Profiles
- SSID/VLAN/Security
- Monitoring
- Commands
- Troubleshooting
- Command Line Interface (CLI)
- General Notes
- Command Line Interface (CLI) Variations
- CLI Command Types
- Using Tables and Strings
- Configuring the AP using CLI commands
- Set Basic Configuration Parameters using CLI Commands
- Set System Name, Location and Contact Information
- Set Static IP Address for the AP
- Change Passwords
- Set Network Names for the Wireless Interface
- Enable 802.11d Support and Set the Country Code
- Enable and Configure TX Power Control for the Wireless Interface
- Configure SSIDs (Network Names), VLANs, and Profiles
- Download an AP Configuration File from your TFTP Server
- Backup your AP Configuration File
- Set up Auto Configuration
- Other Network Settings
- Configure the AP as a DHCP Server
- Configure the DNS Client
- Configure DHCP Relay
- Configure DHCP Relay Servers
- Maintain Client Connections using Link Integrity
- Change Wireless Interface Settings
- Set Ethernet Speed and Transmission Mode
- Set Interface Management Services
- Configure Syslog
- Configure Intra BSS
- Configure Wireless Distribution System
- Configure MAC Access Control
- Set RADIUS Parameters
- Set Rogue Scan Parameters
- Set Hardware Configuration Reset Parameters
- Set VLAN/SSID Parameters
- Set Security Profile Parameters
- CLI Monitoring Parameters
- Parameter Tables
- CLI Batch File
- ASCII Character Chart
- Specifications
- Technical Services and Support
- Statement of Warranty
Command Line Interface (CLI) AP-700 User Guide
General Notes
159
CLI Error Messages
The following table describes the error messages associated with improper inputs or expected CLI behavior.
Tab Complete the command line
? List available commands
Error Message Description
Syntax Error Invalid syntax entered at the command prompt.
Invalid Command A non-existent command has been entered at the command prompt.
Invalid Parameter Name An invalid parameter name has been entered at the command prompt.
Invalid Parameter Value An invalid parameter value has been entered at the command prompt.
Invalid Table Index An invalid table index has been entered at the command prompt.
Invalid Table Parameter An invalid table parameter has been entered at the command prompt.
Invalid Table Parameter Value An invalid table parameter value has been entered at the command prompt.
Read Only Parameter User is attempting to configure a read-only parameter.
Incorrect Password An incorrect password has been entered in the CLI login prompt.
Download Unsuccessful The download operation has failed due to incorrect TFTP server IP Address or file
name.
Upload Unsuccessful The upload operation has failed due to incorrect TFTP server IP Address or file
name.
Key Combination Operation