User guide
Table Of Contents
- Introduction
- Installation and Initialization
- System Status
- Advanced Configuration
- System
- Network
- Interfaces
- Management
- Filtering
- Alarms
- Bridge
- QoS
- Radius Profiles
- SSID/VLAN/Security
- Monitoring
- Commands
- Troubleshooting
- Command Line Interface (CLI)
- General Notes
- Command Line Interface (CLI) Variations
- CLI Command Types
- Using Tables and Strings
- Configuring the AP using CLI commands
- Set Basic Configuration Parameters using CLI Commands
- Set System Name, Location and Contact Information
- Set Static IP Address for the AP
- Change Passwords
- Set Network Names for the Wireless Interface
- Enable 802.11d Support and Set the Country Code
- Enable and Configure TX Power Control for the Wireless Interface
- Configure SSIDs (Network Names), VLANs, and Profiles
- Download an AP Configuration File from your TFTP Server
- Backup your AP Configuration File
- Set up Auto Configuration
- Other Network Settings
- Configure the AP as a DHCP Server
- Configure the DNS Client
- Configure DHCP Relay
- Configure DHCP Relay Servers
- Maintain Client Connections using Link Integrity
- Change Wireless Interface Settings
- Set Ethernet Speed and Transmission Mode
- Set Interface Management Services
- Configure Syslog
- Configure Intra BSS
- Configure Wireless Distribution System
- Configure MAC Access Control
- Set RADIUS Parameters
- Set Rogue Scan Parameters
- Set Hardware Configuration Reset Parameters
- Set VLAN/SSID Parameters
- Set Security Profile Parameters
- CLI Monitoring Parameters
- Parameter Tables
- CLI Batch File
- ASCII Character Chart
- Specifications
- Technical Services and Support
- Statement of Warranty
Installation and Initialization AP-700 User Guide
AP-700 Hardware Description
13
AP-700 Hardware Description
Overview
The AP-700 is a tri-mode AP that supports 802.11b, 802.11g, or 802.11a clients. The unit contains one embedded
802.11a/b/g radio that supports the following operational modes:
• 802.11a only mode
• 802.11b only mode
• 802.11g only mode
• 802.11b/g mode
• 802.11g-wifi
NOTE: In countries in which 802.11a (5 GHz) is not available for use, the AP-700 provides dual-band (802.11b and
802.11g) support only. 802.11a functionality covered in this User Guide is not supported.
The AP-700 can be powered through either PoE (802.3af Power-over-Ethernet) or through an external DC power source
using the power cord.
The AP-700 includes a a power jack, a 10/100 base-T Ethernet port, and an RS-232 serial data communication port. See
Figure 2-1. The AP includes an optional security cover that can be installed to protect against access to the power and
LAN cables and to the reset and reload buttons.
Figure 2-1 Rear Panel
The unit has been designed to rest horizontally on a flat surface, but can be wall- or ceiling- mounted with the long axis
vertical. The unit includes screw slots in the bottom plastic for mounting to a flat wall or ceiling.
LED Indicators
The top panel of the AP-700 has the following LED indicators. See Power On the Unit for a description of LED behavior.