User guide
Table Of Contents
- Introduction
- Installation and Initialization
- System Status
- Advanced Configuration
- System
- Network
- Interfaces
- Management
- Filtering
- Alarms
- Bridge
- QoS
- Radius Profiles
- SSID/VLAN/Security
- Monitoring
- Commands
- Troubleshooting
- Command Line Interface (CLI)
- General Notes
- Command Line Interface (CLI) Variations
- CLI Command Types
- Using Tables and Strings
- Configuring the AP using CLI commands
- Set Basic Configuration Parameters using CLI Commands
- Set System Name, Location and Contact Information
- Set Static IP Address for the AP
- Change Passwords
- Set Network Names for the Wireless Interface
- Enable 802.11d Support and Set the Country Code
- Enable and Configure TX Power Control for the Wireless Interface
- Configure SSIDs (Network Names), VLANs, and Profiles
- Download an AP Configuration File from your TFTP Server
- Backup your AP Configuration File
- Set up Auto Configuration
- Other Network Settings
- Configure the AP as a DHCP Server
- Configure the DNS Client
- Configure DHCP Relay
- Configure DHCP Relay Servers
- Maintain Client Connections using Link Integrity
- Change Wireless Interface Settings
- Set Ethernet Speed and Transmission Mode
- Set Interface Management Services
- Configure Syslog
- Configure Intra BSS
- Configure Wireless Distribution System
- Configure MAC Access Control
- Set RADIUS Parameters
- Set Rogue Scan Parameters
- Set Hardware Configuration Reset Parameters
- Set VLAN/SSID Parameters
- Set Security Profile Parameters
- CLI Monitoring Parameters
- Parameter Tables
- CLI Batch File
- ASCII Character Chart
- Specifications
- Technical Services and Support
- Statement of Warranty
Advanced Configuration AP-700 User Guide
Radius Profiles
104
– Obtained during the Authentication process and used for determining the time interval for sending Accounting
Update messages.
– This attribute value takes precedence over the value of the Accounting Update Interval.
Accounting Attributes
• Acct-Delay-Time
– Indicates how many seconds the AP has been trying to send a particular packet related to a particular user. This
time can be used at the server to determine the approximate time of the event generating this accounting request.
• Acct-Session-Id
– Unique accounting ID that aids in tracking client accounting records. This attribute is sent in Start and Stop
RADIUS accounting messages, and contains the client MAC address appended with the unique session ID.
•Acct-Session-Time
– Acct-Session-Time is calculated the following way (for each transmitted/retransmitted Acct-Stop):
Acct-Session-Time = time of last sent packet - subscriber login time.
• Acct-Input-Octets
– Number of octets (bytes) received by subscriber.
• Acct-Output-Octets
– Number of octets (bytes) sent by subscriber.
• Acct-Input-Packets
– Number of packets received by subscriber.
• Acct-Output-Packets
– Number of packets sent by subscriber.
• Acct-Terminate Cause
– Indicates how the session was terminated.
• Vendor Specific Attributes