Access Point User Guide
Table Of Contents
- Introduction
- Installation and Initialization
- System Status
- Advanced Configuration
- System
- Network
- Interfaces
- Management
- Filtering
- Alarms
- Bridge
- QoS
- Radius Profiles
- SSID/VLAN/Security
- Monitoring
- Commands
- Troubleshooting
- Command Line Interface (CLI)
- General Notes
- Command Line Interface (CLI) Variations
- CLI Command Types
- Using Tables and Strings
- Configuring the AP using CLI commands
- Set Basic Configuration Parameters using CLI Commands
- Set System Name, Location and Contact Information
- Set Static IP Address for the AP
- Change Passwords
- Set Network Names for the Wireless Interface
- Enable 802.11d Support and Set the Country Code
- Enable and Configure TX Power Control for the Wireless Interface(s)
- Configure SSIDs (Network Names), VLANs, and Profiles
- Download an AP Configuration File from your TFTP Server
- Backup your AP Configuration File
- Set up Auto Configuration
- Other Network Settings
- Configure the AP as a DHCP Server
- Configure the DNS Client
- Configure DHCP Relay
- Configure DHCP Relay Servers
- Maintain Client Connections using Link Integrity
- Change your Wireless Interface Settings
- Set Ethernet Speed and Transmission Mode
- Set Interface Management Services
- Configure Syslog
- Configure Intra BSS
- Configure Wireless Distribution System
- Configure MAC Access Control
- Set RADIUS Parameters
- Set Rogue Scan Parameters
- Set Hardware Configuration Reset Parameters
- Set VLAN/SSID Parameters
- Set Security Profile Parameters
- CLI Monitoring Parameters
- Parameter Tables
- CLI Batch File
- ASCII Character Chart
- Specifications
- Technical Support
- Statement of Warranty
- Regulatory Compliance
Installation and Initialization AP-4000 Series User Guide
Product Package
24
Product Package
Each AP-4000/4000M/4900M comes with the following:
• AP-4000/4000M/4900M unit (with integrated 802.11a radio and 802.11b/g radio, and Active Ethernet)
• Power adapter
• One ceiling or wall mounting plate
• Security cover
• One Installation CD-ROM that contains the following:
– Software Installation Wizard
– ScanTool
–MIBs
– User’s Guide in PDF format
– Xtras folder containing the following
• SolarWinds® TFTP software
• Ekahau™ Site Survey software
• Acrobat® Reader software
•One Quick Start Flyer
If any of these items are missing or damaged, please contact your reseller or Technical Support (see Technical Support
for contact information).
System Requirements
To begin using an AP, you must have the following minimum requirements:
• A 10Base-T Ethernet or 100Base-TX Fast Ethernet switch or hub or cross-over Ethernet cable
• At least one of the following IEEE 802.11-compliant devices:
– An 802.11a, 802.11b, or 802.11b/g client device
• A computer that is connected to the same IP network as the AP and has one of the following Web browsers installed:
– Microsoft® Internet Explorer 6 with Service Pack 1 or later and patch Q323308
– Netscape® 7.1 or later
(The computer is required to configure the AP using the HTTP interface.)