Access Point User Guide
Table Of Contents
- Introduction
- Installation and Initialization
- System Status
- Advanced Configuration
- System
- Network
- Interfaces
- Management
- Filtering
- Alarms
- Bridge
- QoS
- Radius Profiles
- SSID/VLAN/Security
- Monitoring
- Commands
- Troubleshooting
- Command Line Interface (CLI)
- General Notes
- Command Line Interface (CLI) Variations
- CLI Command Types
- Using Tables and Strings
- Configuring the AP using CLI commands
- Set Basic Configuration Parameters using CLI Commands
- Set System Name, Location and Contact Information
- Set Static IP Address for the AP
- Change Passwords
- Set Network Names for the Wireless Interface
- Enable 802.11d Support and Set the Country Code
- Enable and Configure TX Power Control for the Wireless Interface(s)
- Configure SSIDs (Network Names), VLANs, and Profiles
- Download an AP Configuration File from your TFTP Server
- Backup your AP Configuration File
- Set up Auto Configuration
- Other Network Settings
- Configure the AP as a DHCP Server
- Configure the DNS Client
- Configure DHCP Relay
- Configure DHCP Relay Servers
- Maintain Client Connections using Link Integrity
- Change your Wireless Interface Settings
- Set Ethernet Speed and Transmission Mode
- Set Interface Management Services
- Configure Syslog
- Configure Intra BSS
- Configure Wireless Distribution System
- Configure MAC Access Control
- Set RADIUS Parameters
- Set Rogue Scan Parameters
- Set Hardware Configuration Reset Parameters
- Set VLAN/SSID Parameters
- Set Security Profile Parameters
- CLI Monitoring Parameters
- Parameter Tables
- CLI Batch File
- ASCII Character Chart
- Specifications
- Technical Support
- Statement of Warranty
- Regulatory Compliance
Specifications AP-4000 Series User Guide
Software Features
219
‡ Support is provided for a primary and backup RADIUS authentication server for both MAC-based authentication and 802.1x authentication
per VLAN.
§ Use in conjunction with WPA or 802.1x Authentication.
Network Functions
* Includes Fallback to Primary RADIUS Server, RADIUS Session Timeout, RADIUS Multiple MAC Address Formats, RADIUS DNS Host Name
Support, RADIUS Start/Stop Accounting.
† DHCP client requests and IP lease renewals are sent on the Ethernet interface only, not on Mesh links.
‡ Available on AP-4000M and AP-4900M only.
Feature Supported by
AP-4000 Series
DHCP Client 3
†
DHCP Server 3
DHCP Relay Agent and IP Lease Renewal 3
†
Inter Access Point Protocol (IAPP) 3
Link Integrity 3
System Logging (Syslog) 3
RADIUS Accounting Support* 3
DNS Client 3
TCP/IP Protocol Support 3
Virtual LAN Support Up to 16 SSIDs and VLANs per
wireless interface, with specific Security
and RADIUS profiles. For more
information, see the Advanced
Configuration chapter.
Mesh Networking 3
‡