Access Point User Guide
Table Of Contents
- Introduction
- Installation and Initialization
- System Status
- Advanced Configuration
- System
- Network
- Interfaces
- Management
- Filtering
- Alarms
- Bridge
- QoS
- Radius Profiles
- SSID/VLAN/Security
- Monitoring
- Commands
- Troubleshooting
- Command Line Interface (CLI)
- General Notes
- Command Line Interface (CLI) Variations
- CLI Command Types
- Using Tables and Strings
- Configuring the AP using CLI commands
- Set Basic Configuration Parameters using CLI Commands
- Set System Name, Location and Contact Information
- Set Static IP Address for the AP
- Change Passwords
- Set Network Names for the Wireless Interface
- Enable 802.11d Support and Set the Country Code
- Enable and Configure TX Power Control for the Wireless Interface(s)
- Configure SSIDs (Network Names), VLANs, and Profiles
- Download an AP Configuration File from your TFTP Server
- Backup your AP Configuration File
- Set up Auto Configuration
- Other Network Settings
- Configure the AP as a DHCP Server
- Configure the DNS Client
- Configure DHCP Relay
- Configure DHCP Relay Servers
- Maintain Client Connections using Link Integrity
- Change your Wireless Interface Settings
- Set Ethernet Speed and Transmission Mode
- Set Interface Management Services
- Configure Syslog
- Configure Intra BSS
- Configure Wireless Distribution System
- Configure MAC Access Control
- Set RADIUS Parameters
- Set Rogue Scan Parameters
- Set Hardware Configuration Reset Parameters
- Set VLAN/SSID Parameters
- Set Security Profile Parameters
- CLI Monitoring Parameters
- Parameter Tables
- CLI Batch File
- ASCII Character Chart
- Specifications
- Technical Support
- Statement of Warranty
- Regulatory Compliance
Command Line Interface (CLI) AP-4000 Series User Guide
Parameter Tables
206
Bridge Parameters
Spanning Tree Parameters
Spanning Tree Priority and Path Cost Table
Storm Threshold Parameters
Name Type Value Access CLI Parameter
Spanning Tree Group N/A R stp
Spanning Tree Status Integer enable (default)
disable
RW stpstatus
Bridge Priority Integer 0 - 65535
32768 (default)
RW stppriority
Maximum Age Integer 600 - 4000
(in 0.01 sec intervals;
i.e., 6 to 40 seconds)
2000 (default)
RW stpmaxage
Hello Time Integer 100 - 1000 (1/100
second; i.e., 1 to 10
seconds); enter values in
increments of 100
200 (default)
RW stphellotime
Forward Delay Integer 400 - 3000
(in 0.01 sec intervals;
i.e., 4 to 30 seconds)
1500 (default)
RW stpfwddelay
Name Type Value Access CLI Parameter
Spanning Tree Table Table N/A R stpbl
Table Index (Port) N/A 1 - 15 R index
Priority Integer 0 - 255
128 (default)
RW priority
Path Cost Integer 1 - 65535
100 (default)
RW pathcost
State Integer disable
blocking
listening
learning
forwarding
broken
R state
Status Integer enable
disable
RW status
Name Type Value Access CLI Parameter
Storm Threshold Group N/A N/A stmthres
Broadcast Threshold Integer 0 - 255 packets/sec
(default is 0)
RW stmbrdthres
Multicast Threshold Integer 0 - 255 packets/sec
(default is 0)
RW stmmultithres