Access Point User Guide
Table Of Contents
- Introduction
- Installation and Initialization
- System Status
- Advanced Configuration
- System
- Network
- Interfaces
- Management
- Filtering
- Alarms
- Bridge
- QoS
- Radius Profiles
- SSID/VLAN/Security
- Monitoring
- Commands
- Troubleshooting
- Command Line Interface (CLI)
- General Notes
- Command Line Interface (CLI) Variations
- CLI Command Types
- Using Tables and Strings
- Configuring the AP using CLI commands
- Set Basic Configuration Parameters using CLI Commands
- Set System Name, Location and Contact Information
- Set Static IP Address for the AP
- Change Passwords
- Set Network Names for the Wireless Interface
- Enable 802.11d Support and Set the Country Code
- Enable and Configure TX Power Control for the Wireless Interface(s)
- Configure SSIDs (Network Names), VLANs, and Profiles
- Download an AP Configuration File from your TFTP Server
- Backup your AP Configuration File
- Set up Auto Configuration
- Other Network Settings
- Configure the AP as a DHCP Server
- Configure the DNS Client
- Configure DHCP Relay
- Configure DHCP Relay Servers
- Maintain Client Connections using Link Integrity
- Change your Wireless Interface Settings
- Set Ethernet Speed and Transmission Mode
- Set Interface Management Services
- Configure Syslog
- Configure Intra BSS
- Configure Wireless Distribution System
- Configure MAC Access Control
- Set RADIUS Parameters
- Set Rogue Scan Parameters
- Set Hardware Configuration Reset Parameters
- Set VLAN/SSID Parameters
- Set Security Profile Parameters
- CLI Monitoring Parameters
- Parameter Tables
- CLI Batch File
- ASCII Character Chart
- Specifications
- Technical Support
- Statement of Warranty
- Regulatory Compliance
Command Line Interface (CLI) AP-4000 Series User Guide
Other Network Settings
177
Enable/Disable Closed System
[Device-Name]>set wif <index> closedsys <enable/disable>
Shutdown/Resume Wireless Service
[Device-Name]>set wif <index> wssstatus <1 (resume)/2 (shutdown)>
Set Load Balancing Maximum Number of Clients
[Device-Name]>set wif <index> lbmaxclients <1–63>
Set the Multicast Rate (802.11a)
[Device-Name]>set wif 3 multrate <6, 12, 24
(Mbits/sec)>
Set the Multicast Rate (802.11b/g)
[Device-Name]>set wif 4 multrate <1,2,5.5,11
(Mbits/sec)>
Enable/Disable Super Mode (802.11a/g only)
[Device-Name]>set wif 3 supermode <enable/disable>
Enable/Disable Turbo Mode (802.11a/g only)
[Device-Name]>set wif 3 turbo <enable/disable>
NOTE: Super mode must be enabled on the interface before Turbo mode can be enabled.
NOTE: Turbo mode and Mesh mode (either Mesh AP or Mesh Portal) can not be enabled on the same interface
simultaneously.
Configure Antenna Diversity
NOTE: When the AP-4900M is configured to use the 4.9 GHz Public Safety operational mode, antenna diversity is
disabled, and antenna 3 is statically configured for use. It is not configurable by the administrator. If an
operational mode other than 4.9 Public Safety is configured, the administrator may manually select which
antenna to use.
[Device-Name]>set wif 3 atdiversity <3, 4, 5(auto)> (see below)
[Device-Name]>set wif 4 atdiversity <1, 2, 5(auto)> (see below)
[Device-Name]>reboot