Access Point User Guide
Table Of Contents
- Introduction
- Installation and Initialization
- System Status
- Advanced Configuration
- System
- Network
- Interfaces
- Management
- Filtering
- Alarms
- Bridge
- QoS
- Radius Profiles
- SSID/VLAN/Security
- Monitoring
- Commands
- Troubleshooting
- Command Line Interface (CLI)
- General Notes
- Command Line Interface (CLI) Variations
- CLI Command Types
- Using Tables and Strings
- Configuring the AP using CLI commands
- Set Basic Configuration Parameters using CLI Commands
- Set System Name, Location and Contact Information
- Set Static IP Address for the AP
- Change Passwords
- Set Network Names for the Wireless Interface
- Enable 802.11d Support and Set the Country Code
- Enable and Configure TX Power Control for the Wireless Interface(s)
- Configure SSIDs (Network Names), VLANs, and Profiles
- Download an AP Configuration File from your TFTP Server
- Backup your AP Configuration File
- Set up Auto Configuration
- Other Network Settings
- Configure the AP as a DHCP Server
- Configure the DNS Client
- Configure DHCP Relay
- Configure DHCP Relay Servers
- Maintain Client Connections using Link Integrity
- Change your Wireless Interface Settings
- Set Ethernet Speed and Transmission Mode
- Set Interface Management Services
- Configure Syslog
- Configure Intra BSS
- Configure Wireless Distribution System
- Configure MAC Access Control
- Set RADIUS Parameters
- Set Rogue Scan Parameters
- Set Hardware Configuration Reset Parameters
- Set VLAN/SSID Parameters
- Set Security Profile Parameters
- CLI Monitoring Parameters
- Parameter Tables
- CLI Batch File
- ASCII Character Chart
- Specifications
- Technical Support
- Statement of Warranty
- Regulatory Compliance
Command Line Interface (CLI) AP-4000 Series User Guide
Set Basic Configuration Parameters using CLI Commands
172
Figure A-13 Results of “show wif” CLI command for an AP
Enable 802.11d Support and Set the Country Code
Perform the following command to enable 802.11d IEEE 802.11d support for additional regulatory domains.
[Device-Name]>set wif <3 (Wireless Interface A) or 4 (Wireless Interface B)> dot11dstatus
<enable/disable>
Perform the following command to set a country code:
[Device-Name]>set syscountrycode <country code>
Select a country code from the following table. Note that not all countries are available for all products. This table is
derived from ISO 3166.
Country Code Country Code Country Code
Algeria DZ Honduras HN Panama PA
Albania AL Hong Kong HK Papua New Guinea PG
Argentina AR Hungary HU Peru PE
Armenia AM Iceland IS Philippines PH
Australia AU India IN Poland PL
Austria AT Indonesia ID Portugal PT
Azerbaijan AZ Ireland 5.8 GHz I1 Puerto Rico PR
Bahrain BH Israel IL Qatar QA
Belarus BY Italy IT Romania RO
Belgium BE Jamaica JM Russia RU
Belize BZ Japan JP Samoa WS
Bolivia BO Japan2 J2 Saudi Arabia SA
Brazil BR Jordan JO Singapore SG
Brunei Darussalam BN Kazakhstan KZ Slovak Republic SK
Bulgaria BG North Korea KP Slovenia SI
Canada CA Korea Republic KR South Africa ZA