Specifications

Configuration Tsunami MP.11 5012-SUR Installation and Management

Management Parameters

SNMP Configuration Settings

• SNMP Interface Bitmask: Configure the interface or interfaces (All Interfaces, Only Ethernet, Only Slot A) from

which you will manage the 5012-SUR using SNMP. You also can select None to prevent a user from accessing the

unit through SNMP.

HTTP Configuration Settings

• HTTP Interface Bitmask: Configure the interface or interfaces (All Interfaces, Only Ethernet, Only Slot A) from

which you will manage the 5012-SUR through the Web interface. For example, to allow Web configuration through the

Ethernet network only, set HTTP Interface Bitmask to Ethernet. You can also select None to prevent a user from

accessing the 5012-SUR from the Web interface.

• HTTP Port: Configure the HTTP port from which you will manage the 5012-SUR through the Web interface. By

default, the HTTP port is 80.

Telnet Configuration Settings

NOTE: To use HyperTerminal for CLI access, make sure to check “Send line ends with line feeds” in the ASCII Setup

window (from the HyperTerminal window, click Properties > Setup > ASCII Setup. See “HyperTerminal

Connection Properties” in the Tsunami MP.11 Reference Manual for more information).

• Telnet Interface Bitmask: Select the interface (All Interfaces, Only Ethernet, Only Slot A or None) from which you

can manage the 5012-SUR through telnet. This parameter can also be used to disable telnet management.

• Telnet Port Number: The default port number for Telnet applications is 23. However, you can use this field if you want

to change the Telnet port for security reasons (but your Telnet application also must support the new port number you

select).

• Telnet Login Timeout (seconds): Enter the number of seconds the system is to wait for a login attempt. The 5012-

SUR terminates the session when it times out. The range is 1 to 300 seconds; the default is 60 seconds.

• Telnet Session Timeout (seconds): Enter the number of seconds the system is to wait during a session while there is

no activity. The 5012-SUR ends the session upon timeout. The range is 1 to 36000 seconds; the default is 900

seconds.

Serial Configuration Settings

The serial port interface on the 5012-SUR is enabled at all times. See “Serial Port” in the Tsunami MP.11 Reference

Manual for information about how to access the CLI interface through the serial port.