Specifications

Installation and Initialization Tsunami MP.11 5012-SUR Installation and Management

Installation Procedure

This section describes the steps required to install and mount the 5012-SUR. If you are already familiar with this type of

product, you can use the Quick Install Guide for streamlined installation procedures.

See the following sections:

• Step 1: Choose a Location

• Step 3: Mount Unit to Pole

• Step 2: Attach Cables

• Step 4: View LEDs/Adjust Mounting

• Step 5: Close Cable Compartment

• Step 6: Tighten Band Clamps/Secure Ethernet Cable

• Step 7: Install Documentation and Software

NOTES:

• The Configure System window provides a selectable Country field that automatically provides the allowed

bandwidth and frequencies for the selected country as well as, where applicable, Dynamic Frequency Selection

(DFS) and Transmit Power Control (TPC).

• Be sure to read the Release Notes file on the product CD as it contains software version and driver information

that may not have been available when this document was produced.

• Equipment is to be used with and powered by an 802.3af-compliant power injector (purchased separately).

IMPORTANT:

Before installing and using this product, see Safety and Regulatory Compliance Information on the

product CD.