Installation guide

Installing the Link Tsunami MP.11 Antenna Installation Guide

Grounding the Antenna

Direct grounding of the antenna mast, radio hardware, and surge arrestor is extremely important.

NOTE: A safety grounding system is necessary to protect your radio hardware from lightning strikes and the build-up of

static electricity.

WARNINGS:

• The antenna mast, radio hardware, and surge arrestor must be connected to the same ground,

using an equi-potential bonding conductor.

• A good electrical connection should be made to one or more ground rods, using at least a 10AWG

ground wire and non-corrosive hardware.

• The grounding system must comply with the safety standards that apply in your country. Always

check with a qualified electrician if you are in doubt whether your radio hardware installation is

properly grounded.