Install guide
MP.11 and MP.11a Quick Install Guide
Switching On the Unit
The MP.11/MP.11a can be powered by a power supply (just plug the power cord of the power supply into an AC
power outlet), or by Active Ethernet (connect an Active Ethernet splitter to the Ethernet cabling).
When the power is switched on, the MP.11/MP.11a performs startup diagnostics. When startup is completed, the
LEDs show the operational state of the MP.11/MP.11a (see the following figure).
The following table shows the status of the LEDs when the MP.11/MP.11a is operational (the fourth LED
is only used during Dynamic Frequency Selection on a BSU; flashing green indicates scanning).
Power
OFF
Power is not present or is malfunctioning.
GREEN Power is present; the unit is operational.
AMBER
The unit is initializing after reboot (less than two
minutes); it cannot get a dynamic IP address.
RED A fatal error in the unit.
Ethernet Link
OFF Not connected.
GREEN Connected at 10 Mbps.
BLINKING GREEN Data is being sent at 10 Mbps.
AMBER
Connected at 100 Mbps, or the unit is initializing
after reboot (less than two minutes).
BLINKING AMBER Data is being sent at 100 Mbps.
RED An error in data transfer.
Wireless Link
OFF
Wireless interface is up properly but no wireless
link established.
GREEN
Immediately after connecting a wireless link.
BLINKING GREEN
Data is being sent or the wireless interface
is initializing after reboot (less than two
minutes).
RED There is a fatal error on the wireless interface.
* See “Forced Reload” Error! Bookmark not defined..
Continue with “Installing Documentation and Software” Error! Bookmark not defined..
Copyright © 2005 Proxim Corporation. All rights reserved. 9