Install guide

MP.11 and MP.11a Quick Install Guide

3. Unlock the unit’s cable cover. To release the cable cover, press down on the cable cover lock located in the

front center of the unit.

4. Remove the cable cover.

5. Remove the front cover from the unit (the side with the LED indicators, shown in the figure on left); then

remove the back cover (figure on right).

6. Connect the grounding wire to the MP.11/MP.11a using the Faston plug on the metal case, next to the power

plug.

7. Connect one end of an Ethernet cable (not supplied) to the Ethernet port. The other end of the cable should

not be connected to another device until after installation is complete.

º Use a straight-through Ethernet cable if you intend to connect the MP.11/MP.11a to a hub, switch, patch

panel, or Active Ethernet power injector.

º Use a cross-over Ethernet cable if you intend to connect the MP.11/MP.11a to a single computer.