Install guide

MP.11 and MP.11a Quick Install Guide

CHANGING THE SECURITY SETTINGS

Proxim highly recommends you change the Network Name and Shared Secret as soon as possible. To do so,

click the Configure button and the Interfaces tab; then click the Wireless sub-tab.

To change the passwords of the MP.11/MP.11a, click the Configure button, then the Telnet, HTTP, or SNMP

tab.

UPGRADING EMBEDDED SOFTWARE

The MP.11/MP.11a is equipped with embedded software. Updates of this software can be found on the Proxim

Internet site.

Not all software releases support all products in the Tsunami MP.11/MP.11a family. Proxim recommends that

you always refer to the Release Notes to determine whether the version of software to which you want to upgrade

is supported on your MP.11/MP.11a product.

To download files to the MP.11/MP.11a, click the Commands button and select the Download tab.

APPLYING CHANGES

To apply your changes to the MP.11/MP.11a, reboot the device. If you do not want to reboot immediately, issue

the CLI save command to ensure your changes are saved. When you do reboot, the MP.11/MP.11a is restarted

with the new settings.

In the Web interface, click the Commands button and the Reboot tab to issue the reboot command.

DEFAULT SETTINGS

The default settings for the MP.11/MP.11a are:

Country: Must be set by the professional installer

DFS: Disabled

TPC: Full (-0dBm)

IP address: DHCP enabled or 10.0.0.1

Subnet mask: DHCP enabled or

255.255.255.0

HTTP password: public

Telnet password: public

SNMP Read password: public

SNMP Read/Write password: public